Mermaids Are Forever My Favorite Thing

mermaids are forever my favorite thing

Two dashing gentlemen here to save the universe 

The Chive Cart (spray booth for faceups)

Most of the problems associated with sealing sprays occur during the action of spraying itself. If there is a lot of moisture in the air (which can also be brought about by cold temperature) during those few seconds while you release the spray, it can get trapped underneath your sealant layer which causes the layer to later crack, craze or chip. Staying indoor, at least during the spraying action, allows me to control my room temperature, source of lighting and I do not have to deal with annoying wind which can cause dust and other particles to get sprayed onto the doll as well. However, I needed a way to encapsulate all that toxic fumes I am about to be spraying. The idea of using a spray booth for this purpose is definitely not new, but thought I’d show you one I made out of am archive box:

I chose this box because it’s not too big and has handles on the sides for portability. Below is a second version of the spray boxy: I’ve cut out the arm holes at differing heights. Because of the way I hold my spray bottle, I just find this position more comfortable.

Here is me putting my spray boxy to use: Video . Right after i finish spraying, i wait a few minutes until the sealant layer settles and solidifies a bit, then i gently place the head on the tissue i got inside the box, take both of my hands out and carry the box by the handle outside of the house. Only when I’m outside, I open the lid of the box to take my doll head out. While i’m out there, i let my boxy air so the fumes dissipate (fanning it helps), sometimes i wipe the inside of the box too to get rid off the sealant that has stuck to the sides. I then put the lid back down and take everything back inside the house. If I need to do another spraying, I repeat this process but start with being outside when I place the object inside of the box, then bring the box inside and wait until the temperature of the air inside the box matches my indoor condition before I begin spraying again. Another Video showing the two designs. Some photos showing how the box was made:

First I cut out some arm holes. I started with same level, but later I figured out that I am more comfortable having the arm holes at differing heights.

Cut the top of the box as well as a bit of the side so I can see a lot more inside the box.

I just used this clear plastic from the back of an old booklet to make my window.

Stick the plastic with duct tape. Also, I make sure the lid opens this way (toward the back), it’s just more practical having it away from me while I spray.

Now I attach some gloves

I use the cardboard from the old booklet to make reinforcements for the arm holes.

I make sure the angle of the gloves will be comfortable for the angle of my arms for when I spray.

I then duct taped the crap out of it. Put all my object and spray in it and I’m ready to go.​

Is this meme still happening?? lol Send me some smooches y’all~ you know the drill 💖 (character+number )

Had some colored pencils and a pen. I asked my coworker for a prompt and got “80’s”.

So of course how could I doodle anything but Keith from the amazing @fenri’s “Alien Sex Fiend”? Tbh it’s only a matter of time before I make fanart for all their fics…

I was gonna add a Shiro with an arm around him, but pen is too unforgiving for me to attempt that today.

“the darkest nights produce the brightest stars”

this picture was possible thanks to my patreons 🌙