More 15-minute Pose Doodles

More 15-minute pose doodles

Printing the cylinder took 3 attempts - first print came loose from the print bed; second print I forgot that you need panel gaps if you want details to be visible from a distanct.

Luckily I modelled it in Fusion360 so I could tweak individual settings without too much difficulty

Drilled a shallow hole in the rear half to hold the spindle

Starting to look like a revolver now

For the muzzle & front cap, I printed them with a raised chamfered lip so I could sharpen the edge and then use them to cut slightly into the foam.

Then they got superglued into place

For the round details, I wanted to try and cut them out with a sharpened tube because I didn't want to try freehanding a circle with a knife. It turns out you can 3d print cutters from PLA and after sharpening with sandpaper they work ok! They do need frequent re-sharpening though.

Cut out part of 2 of the big circles, glued to the other big circles, then added the small circles on the other side - and the hinge details are done

Propped up like this for a progress shot because I don't want to glue the cylinder in before painting.

Not much left to actually make before painting either...

MechaTriceratops - now available on Redbubble

Artfight Week 4 (and a bit)

1) TregRyder

2) Arcaneasteroid

3) Alieraah

4) Cylunny

5) Emp

6) CarefreeGhostie

7) @razziliciousart